Ranco ETC Error message

[Zucker Bee]

I often get a E2 error mesage on my Ranco controler. It usppose to mean "Check all settings and correct if necessary" but... what does that mean, really?

The only way I work around the problem is by unplugging the device for a few seconds and plug it back, but this time it wont work. AND I NEED TO CRASH MY BEEEER :mad:

All my settings are the same as they've always been, and it's only programmed for cooling, so no possible conflicts.

Please help

Zb

[fdkassik]

Is your unit 24v or 110? Mine are 24v and the only thing that comes to mind is that maybe you have a problem with the transformer. Check your incoming voltage with a multimeter. Also your connections to your thermistor probes may be giving you problems. They work on resistance and if you have corroded connections you can get a false reading or loose feed to your controller which will give you the error code also. I did have to replace one probe on my boil kettle (different unit but same voltage) but generally they work really well and it turns out to be the connections. Hope this helps.
Frank Kassik
Kassik's Brew Stop
www.kassikskenaibrewstop.com

[Zucker Bee]

Thanks. I'm on 110v

I was hoping to get cues concerning the "programming" but everyting points to a physical defect. Will get down to it

Zb