Used Product Ad posted 7 hours ago in Miscellaneous Equipment by Matt Crawford
Only used twice 3.5" TC dump port 2" TC vortex inlet & outlet 2oolb hop pellet capacity Local pickup or shipping available $10,000 USD OBO
Used Product Ad posted 1 day ago in Miscellaneous Equipment by Kyle Jones
Never used, sat around the brewery so just dusty. GPI FLOMEC TURBINE METER 3/4" SS SCLAMP INNER DIAMETER: 3/4 IN; TRI-CLOVER; FLOW RANGE: 2-20 GPM; OPERATING TEMP: 0-140 F; PRESSURE RATING: 1500 PSI; FREQUENCY: 37-370 HZ AT 2-20 GPM; WETTED PARTS: 316 SS HOUSING, CERAMIC BEARINGS, TUNGSTEN CARBIDE SHAFT, PVDF ROTOR, 316 SS RINGS They are $1,100 brand new: https://www.flows.com/liquid-flow-meters-g2-series/?sku=G2S07TQ9GMA&campaign=18334319452&content=&keyword=&gad_source=1&gclid=Cj0KCQiAvP-6BhDyARIsAJ3uv7aNyBhhNbNxYO_DhW6ceGveo_1A_Rz7rlOeM4WlPbO6cxs1bXa-o9MaApIREALw_wcB
Used Product Ad posted 4 days ago in Miscellaneous Equipment by Sean Shoyoqubov
Never used very heavy duty and high quality 120L pharmaceutical grade mixing/blending tank on casters. It has a diaphragm valve at the bottom discharge port and a magnetic mixer. Made of 7.5 mm stainless steel. Italian Rattiinox BTV valve, Swedish-made motor and gearbox, tank itself made in Quebec, Canada. Would work great at a yeast propagator, yeast brink or chemical dosing tank. Will crate for free and can help arrange freight. Asking $3,000 US Dollars or $4,300 Canadian.
Used Product Ad posted 6 days ago in Miscellaneous Equipment by Kate McAllister
HD125 Power Vented Propeller Overview: Tubular Power Vented Propeller 125,000 BTU/hr input Application: Large Garage (more than 3-1/2 car garage) Heat Exchanger: Aluminum Direct Spark Ignition 115V, 60 hertz, single phase Single Stage, Natural Gas Hush-puppy quiet operation (see table) Right or left hand controls available on all 30-75 units. Gas, electrical and flue connections can be changed by simply flipping the Hot Dawg over Uses natural or propane gas Lightweight, easily installs 1" from ceiling with only two angle brackets (included on sizes 30-75, accessory for 100, 125) Full 10-year warranty on heat exchanger Standard power exhaust simplifies side-wall or roof venting with small-diameter vent pipe Permanently-lubricated motor for trouble-free dependability single stage, direct spark ignition, 100% shut-off with continuous retry Low-profile design and neutral color to blend in with decor
Used Product Ad posted 1 week ago in Miscellaneous Equipment by Stefan Popescu
Looking for an easy way to diversify your offerings, both in the taproom and out in the market? The Alchemator allows craft brewers and beverage producers to easily separate the alcohol and water from any fermented beverage. Simply add deaerated water to the remaining concentrate to make full-flavored low-alcohol or nonalcoholic beer or beverage from the original beer. This allows for a crystal clear seltzer (not always the easiest to obtain) and for that NA option which falls in line with the profile of your current offerings without having to reinvent the wheel. Brand new, these typically go for $80k+. We bought this item used, but our business model changed before ever putting it to use. Ready to ship today.
Used Product Ad posted 1 week ago in Miscellaneous Equipment by Cameron Collier
15 HP screw air compressor with air dryer and large storage tank. Single owner with not mechanical issues.
Used Product Ad posted 1 week ago in Miscellaneous Equipment by Keith Redhead
Never been used. Perfect condition.
Used Product Ad posted 1 week ago in Miscellaneous Equipment by Adam Shay
Small pressure vessel built inhouse using Precision Stainless Tank S/N 5924-23, 1998. List of other available equipment can be found at www.carolinaprocessequipment.com
Used Product Ad posted 2 weeks ago in Miscellaneous Equipment by Mike Dryburgh
Brand new, never been used 10 bbl Koelschip (coolship) for sale. Single drain, 1 1/2″ TC. Contact for pricing and information.
Used Product Ad posted 2 weeks ago in Miscellaneous Equipment by Thorin Peiser
50 lb capacity. Used once then cleaned and stored dry. Still has tape on the wheels from when originally shipped. Too big for our operation. Located in Austin, TX. From CPE website: (https://www.cpesystems.com/products/mh-20-hop-induction-system) “The MH-20 Hop Induction System (HIS) greatly increases the ease and safety of the dry hopping process. Attached to select centrifugal or shear pumps, the MH-20 HIS hygienically suctions hops into your beer with minimal oxygen introduction. This completely eliminates the need for scissor lifts or shaky ladders, decreasing workload and greatly increasing safety. With the MH-20 HIS just load your hops, start your pump, turn the valve, and within minutes your hops are in the tank. We have added a pneumatic vibrator to the hopper to improve the flow of the hops and to help prevent bridging and clogs. We've custom designed the MH-20 based on feedback from our local breweries: Light and easy to move...
Used Product Ad posted 2 weeks ago in Miscellaneous Equipment by Matt Couch
We have a plethora of left over PREINSULATED Schedule 80 PVC piping and fittings. The items were unused on various projects throughout the year. Here is a breakdown of the items we have currently. All items are preinsulated: 17 x 10 foot lengths of 2" ID pipe with 4" PVC coated jacket @ $200 per length 25 x 10 foot lengths of 1" ID pipe with 3" PVC coated jacket @ $190 per length 15 x 2" 90 degree elbow with 6" PVC hard shell jacket @ $45 per unit 16 x 2" 45 degree elbow with 6" PVC hard shell jacket @ $40 per unit 18 x 2" Equal Tee with 6" PVC hard shell jacket @ $50 per unit 5 x 2" Coupling with 6" PVC hard shell jacket @ $30 per unit 8 x 2" x 1" Reducer coupling with 6" PVC hard shell jacket @ $60...
Used Product Ad posted 2 weeks ago in Miscellaneous Equipment by Cullen Dwyer
In-line carbonation of beverages at flow rates up to 100BBL/min. The center-piece of the system is the carbonation chamber itself: manufactured by Wittemann with two fritted stainless-steel disks to force CO2 into the beverage and bolted flat-flange connections at either end. This unit is fitted with 2-inch and 3-inch triclover adapters, and mounting brackets. System comes complete with original manifold, valves and gauges to control carbonation levels, as well as extras: mounting hardware, a rotometer/flow-meter and a solenoid valve to stop carbonation during pauses of process flow. Buyer will be additionally charged estimated cost of UPS shipping.